Cleanlet bidet installation, made simple
Cleanlet bidet installation is refreshingly simple: the unit fits most existing toilets, connects to the mains, and — unlike most electronic bidets in New Zealand — needs no expensive RPZ valve, because backflow prevention is built in.
Installing your bidet toilet seat
Most people have their Cleanlet up and running in well under an hour — full instructions come with every manual. Here's the whole job.
*All bidets must be installed by a plumber under the plumbing regulations.
Remove the cistern pipe
Disconnect the flexible hose from the cistern tap.
Fit the flexible hose
Fit the supplied "tee" to the cistern tap and reconnect the hose to the cistern.
Connect to your Cleanlet
Using the supplied flexible hose connect the tee to the Cleanlet bidet and turn the cistern tap ON. Check for leaks.
Plug in and go
Plug the bidet into an RCD protected 3-pin socket.
Cleanlet bidet seat dimensions
The Cleanlet mounting system adjusts to suit a wide range of toilet pans for a neater, more pleasing finish. Each diagram below shows the Cleanlet unit and its own measurements, drawn over the pan it fits — so you can see both at once. Measure your pan, match your figures to A, B, C and D, and that tells you which seat size you need. Select any measurement, on the drawing or in the list, to see exactly what it covers. All measurements are in millimetres. If your figures fall outside these ranges, contact us before you buy.
Standard size seatFor pans measuring within the ranges below.
Elongated size seatFor longer pans, where B, C and D reach or exceed these figures.
Not sure which one you've got? Send us your measurements and we'll confirm before you order.
Check my panWe're happy to talk you through it
Whether it's fitting, pans or compliance, we've done this since 1998 — call us or drop us a line and we'll sort you out.